If the switch is recessed, then use a non-conductive object, such as a wooden pencil, to depress the switch. It may have a protruding button or spike or more likely it is a hole with a piece of metal or plastic inside it. Now, inspect the cabinet where the door makes contact with it and locate the door switch. Do not reach inside the dishwasher during the test. 2 Step two: Remove both the control panel and door panel 1.3. Make sure to first remove all tools from inside the dishwasher. How to Fix Dishwasher Soap Dispenser Door Latch 1 Step one: switch off the dishwasher 1.3. Note that if the test is successful, with the door open, the dishwasher will operate and water may spray out. Simply open the door, close the latch and select a cycle and depress the switch. It is a simple matter to determine whether the door latch is the problem. Instructions Shut off electrical power Remove the outer door panel and control panel Remove the door latch assembly Install the new door latch assembly. ![]() Always latch trash compactor and dishwasher. Verify that the door latch is in the correct position when the door is. Install safety latches on all cupboards and airtight containers, including refrigerators, chests or coolers. Unless the switch is fully depressed the dishwasher will not operate. An undamaged door latch mechanism should look like this picture when the door is open. The part should simply snap into place against the grooves by the. If the door latch is not properly aligned it may not pull the door tightly closed and the door switch will not be fully depressed. Slide the new door latch strike into the cavity with the latch hole oriented to the front. Only when the door is closed and latched, does the door fully depress the switch. Closing the door does not depress the switch all the way. Depressing the switch closes the circuit and enables dishwasher operation. The door switch is a separate part from the door latch and is found inside the cabinet. If your dishwasher has a locking tab you will have to re. First plug the wires into the new door latch assembly and then Insert the assembly. Now you should be able to remove the door latch assembly. Once unplugged you may have to release locking tabs. The door latch works in concert with the door switch to ensure that the door is tightly closed and latched.Ĭaution: Please read our safety information before attempting any testing or repairs. Unplug the wires attached to the door latch assembly. ![]() It is also designed to prevent operation while the door is open. The door latch pulls the door tightly closed to prevent water leakage around the door.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |